Ana karɓar abubuwan da aka dawo da su cikin kwanaki 40 tun ranar karɓar kayan. Ba za a iya mayar da abubuwan da aka keɓance ba. Abubuwan da aka saya tare da katin kyauta ana iya musayar su kawai.
Kyauta Kyauta
Barka da zuwa Roymall, shafinku na siyan kyaututtuka masu inganci. Muna girmama goyon bayanku, kuma muna ba da kyauta kyauta tare da kowane siyayya.Shirya don bincika tarinmu kuma ku sami kyaututtukanku masu dacewa.
Manufar Jigilar Kaya
Za mu aika kayanku cikin kwanaki 2 bayan siyayya.Lokacin jigilar kaya yawanci kwanaki 5-7 ne.Saboda jigilar mu ta duniya ne, lokacin jigilar zai dogara da wurin ku.
1. Manufar Komawa
Muna karɓar abubuwan da aka saya daga roymall.com kawai.Ba za a iya mayar da kyauta kyauta ba.Dole ne abu ya kasance ba a yi amfani da shi ba kuma a cikin yanayin da kuka karɓa.Za mu sarrafa komawar ku cikin kwanaki 3-5 bayan karɓa.Ba za a iya mayar da abubuwan da aka keɓance ba.Tuntuɓi mu. service@roymall.com ko Whatsapp: +447549870296
2.Manufar Maida Kuɗi
Za ku sami cikakken maida kuɗi bayan mu karɓi abubuwan da aka dawo.Kuɗin jigilar kaya ba za a iya mayar da su ba.Tuntuɓi mu. service@roymall.com ko Whatsapp: +447549870296
Videos for similar product
Loading product videos...
❮
❯
Products related to this item
Loading related products...
❮
❯
Feature:
Model: STM32F103C8T6
Kernel: ARM32 bit Cortexu2122-M3CPU
Size: 22.86mm x 53.34mm
Debug Mode: SWD
MCU Introduction:
1. The maximum operating frequency of 72MHz
2. Single-cycle multiply and hardware divide
3. 64k Flash program memory
4. 20k bytes SRAM
5. 2.0-3.6V power supply and I / O pins
6. On power-up, power reset (POR / PDR), programmable voltage monitor
7. 4-16MHz crystal oscillator
8. Embedded 8MHz RC oscillator
9. generates CPU clock PLL
10. Sleep Stop Standby mode
11. VBAT power for the RTC back registers
12. 37 Quick I / O ports, the I / O ports can be mapped to 16 external interrupts etc.
The PCB with STM32F103C8T6 on board works fine, can be programmed from stm programmers. It is one very serious trouble - ADC noise is very very larga, more than 5-6 units becouse of pcb desing. Be carefull with using the pcb as ADC. You can see the ADC noise on Figure.
The edges of the PCB are not burnished, but it is not a big deal - can be done easy with sandpaper.
There is one design issue with this 48 pin package - the CAN module and the USB share the same pins, that means that you can't use both in same project.
Roymall C.o.
Kyauta Kyauta
Manufar Jigilar Kaya
Manufar Komawa
Coupon Code
Direct purchase from the factory 
Electronic Components & Supplies
Motherboard & Development Board
