1.Using imported welding needles from the United States, it can be disassembled and replaced, and the welding points are beautiful and firm
2. Comes with a high-rate lithium battery, which can be used after opening
3.High-definition digital tube display, monitor the remaining battery power
4.The current output size can be adjusted at will
5. Support manual welding
6.Rechargeable
7. Low power consumption after shutdown
Instructions:
1. Power on:turn on the knob, the indicator light flashes 3 times
quickly and then turns on, the boot is successful
2. Shutdown: Turn off the knob
3.Welding: Two welding pens are placed on the nickel sheet,
press the foot switch and hold, after the red light flashes 3 times quickly, output a current to complete the welding
4.The knob can adjust the output current, the larger the value,
the higher the output

Note:

Try to avoid using while charging, it is easy to damage the battery
When the temperature of the soldering too high, please use it after cooling
Charge in time when the voltage is lower than 7.3V
Please use the ambient temperature between 10 degrees and 65 degrees. Do not enter water. Before using this machine Please understand the operating instructions first Battery spot welding machine operation requirements and daily use points:

1.Put the nickel sheet on the lithium battery, use the 18650 battery clamp to move the nickel sheet, step on Step down the pedal, OK to complete the welding
2.When welding, be sure to press the nickel sheet and the battery with two needles
3. Welding pins cannot touch together
4.According to the welding effect of the actual product, the welding parameters can be adjusted in a targeted manner. Until a satisfactory welding effect is achieved
5.Inspection: Check whether the welding needle has carbon deposits, if so, use a file or sand paper to remove it