ESP32 ESP32S 18650 Battery Charge Shield V3 Micro USB Type-A USB 0.5A Test Charging Protection Board Geekcreit for Arduino - products that work with official Arduino boards
Sɔnni segin bɛ se ka sɔrɔ 40 don kɔnɔ Sɔnni yɛlɛman tɛ segin Sɔnniw minnu bɛ sɔn ni kaati hɔrɔn, olu tɛ segin
Sɔnni Hɔrɔn
I ni ce Roymall, i ka sɔnniw siti. An bɛ i ka dɛmɛ fɛɛrɛ. O sɔnni hɔrɔn bɛ kɛ i ka sɔnni kɛnɛ kan.
Ka Taa Cogo
An bɛ sɔnniw taa i ka so la 2 don kɔnɔ. Kɛnɛ cɛsiri bɛ se ka kɛ 5-7 don kɔnɔ.
1. Ka Segin Cogo
Sɔnniw bɛ segin 40 don kɔnɔ. Sɔnni yɛlɛman tɛ segin.
2.Ka Sɛn Segin
I bɛ sɛn sɔrɔ segin kɔnɔ.
Videos for similar product
Loading product videos...
❮
❯
Products related to this item
Loading related products...
❮
❯
Note:
This module is suitable for 18650 battery only
This module can be powered or for raspberry pi and sensor at the same time
This module output current up to 2A (This product does not contain 18650 battery installation, be careful of the battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder)
Features:
1. With over-charging protection and over-discharge protection
2. Micro USB charging interface
3. Charge current: 0.5A
4. 1 switches to control the USB output
5. Input voltage: 5 ~ 8V
6. Three 3V 1A output interface
7. Three 5V 2A output interface
8. LED light, green for full of charge, red for under charging
Roymall C.o.
Sɔnni hɔrɔn
Ka taa cogo
Ka segin cogo
Coupon Code
Direct purchase from the factory 
Electronic Components & Supplies
Module Board
Test & Measuring Module
